HID HDP5000 User Manual page 164

All rights reserved
Troubleshooting with the LCD Error Message Table
LCD Error Message
Lam Handler Startup
Error
(PC Error Message
No. 141)
Lam Internal Error
(PC Error Message
No. 48)
Lam No Film
(PC Error Message
No. 157)
Lam Timeout
(PC Error Message
No. 247)
Lam1 Wrong Film
(PC Error Message
No. 233)
Lam2 Wrong Film
(PC Error Message
No. 234)
Laminate 1 Bad
(PC Error Message
No. 259 and 261)
HDP5000 High Definition Card Printer/Encoder User Guide
Cause
After powering up the
Printer, the Laminator was
detected, but an error
occurred which would
prevent its use.
A generic unknown error as
occurred in the Laminator.
There is no material loaded
in the Laminator.
The Printer timed out while
processing information
related to the Laminator.
Material in Cartridge 1 of the
Laminator does not match
the material type specified
by the job.
Material in Cartridge 2 of the
Laminator does not match
the material type specified
by the job.
The Lamination material in
Cartridge 1 is not valid for
this Laminator.
HID Global Corporation
Solution
Check Laminator power and
connections and restart the
Printer.
Check Laminator power and
connections and restart the
Printer.
Load Laminator material.
Check Lam power/connections
and restart the Printer.
Make sure Driver material
matches what is actually in the
Laminator.
Make sure Driver material
matches what is actually in the
Laminator.
Install valid material.
L000950 Rev 1.8 164