Conducting The Tape Adhesion Test - HID HDP5000 User Manual

High definition card printer/encoder

Hide thumbs Also See for HDP5000:

Table of Contents

Conducting the Tape Adhesion Test

If the tape test indicates inadequate adhesion, increase the heat setting by 5

degrees, print another card and try the tape test again.

Once the temperature has been increased 4 times (20 degrees), reset

temperature to default and increase the Dwell Time by .5 second.

Repeat this process until adequate adhesion is achieved.

Ensure that the cards (in use) have a surface roughness (Ra) of 60 micro

inches or less.

This information should be available from the card manufacturer.

HDP5000 High Definition Card Printer/Encoder User Guide

HID Global Corporation

L000950 Rev 1.8