Using The Eat Disable Option; Using The Film Print Cooling Level Option; Using The Film Transfer Cooling Level Option; Using The Enable Ribbon Wrinkle Compensation Option - HID HDP5000 User Manual

All rights reserved HID Global Corporation

Using the EAT Disable Option

This is and ON or OFF switch. 0 is off and 1 is on. This will tell the printer to keep track of the
environmental temperature and compensate for it.
"Environmentally Adaptive Transfer" automatically adjusts the transfer temp based on the
ambient air conditions within the printer. Will increase or decrease the transfer roller temp by
as much as 20C in extreme conditions.
This mode defaults to on and a setting of "1" will disable.

Using the Film Print Cooling Level Option

This controls the speed of the transfer roller cooling fan during the printing process.
This setting should normally be off, but can be turned on to help with splotchy color areas on
the image. Too high fan speed can cause smudge.

Using the Film Transfer Cooling Level Option

This controls the default speed of the cooling fan for the transfer process.
Adjusts fan speeds and on times during transferring. This setting affects both flash and
smudge.

Using the Enable Ribbon Wrinkle Compensation Option

This is an on or off switch. When this enabled it will turn on extra pixels on the printhead to
help with ribbon wrinkle during the print process.

Using the Holo Transfer Offset Option

This option changes the Hologram Overlamiate Offset for placement parameters.

Using the Standby Temp Option

This option changes the temperature used when the printer is in standby mode.
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8 296