Preventing Moisture Condensation; Installing The Lamination Module Accessory - HID HDP5000 User Manual

All rights reserved

Preventing Moisture Condensation

If the unit is brought directly from a cold to a warm location or if the unit is placed in a very
damp room, moisture may condense inside the unit. (Note: If this condition occurs, print
quality may not be at its optimum level.)
Follow this guideline:
•
Leave the unit turned OFF in a warm, dry room for several hours before using it. (Note:
This will allow the moisture to evaporate.)

Installing the Lamination Module Accessory

Parts included: Lamination Module Accessory Kit, PCB-INTF Board, Torx Tool and screws.
Tools needed: Torx Tool included in kit.
Estimated Repair Time: 10 minutes.
Step Procedure
1
Caution: Power off the Printer by unplugging the power cord from
the Printer.
2 Remove the USB, Serial, Ethernet communication connections.
Important: Do not remove the Covers for this procedure.
3 The Lamination Module is installed at the output side of the Flipper Module.
OR
If there is no Flipper Module, it is installed at the output side of the Printer.
Remove the Card Output Hopper.
4 a. Remove the Output Side Upgrade Cover (D910139-01).
b. Release the latch on the upgrade cover.
c. Pull on the bottom of the upgrade cover to remove it from the printer.
5 a. Turn the Printer and the Flipper Module on their back.
b. Use the Torx tool provided to remove the two (2) screws from the bottom
of the Flipper Module. Save the screws for later for reattachment.
HDP5000 High Definition Card Printer/Encoder User Guide
HID Global Corporation
L000950 Rev 1.8 264