Changing The Aneg Setting - HID HDP5000 User Manual

All rights reserved

Changing the ANEG setting

The ANEG status indicates the current setting of the network configuration of the Ethernet
interface.
•
This value can be set explicitly by the User to force the Ethernet interface configuration in
cases where auto negotiation fails.
•
Failure of the automatic network configuration can cause slow data transmission, longer
print times or network connection problems.
Follow the procedure provided below.
Step Procedure
1 See the Accessing the Network Setup Menu
Network Settings menu (Options ->Menu -> Next -> Network Settings).
2 Select Next on the LCD to view the ANEG: menu entry.
3 Press the Change button to change the auto negotiation setting for the
Printer, which will rotate between the following:
•
ANEG: AUTO: Allows the auto negotiation between the Printer and the
host Ethernet interface.
•
ANEG: Full Dup: Forces the full duplex communications between the
Printer and the host Ethernet interface.
•
ANEG: Half Dup: Forces the half duplex communications between the
Printer and the host Ethernet interface.
4 If you change the setting, you will be prompted to reboot the Printer.
HDP5000 High Definition Card Printer/Encoder User Guide
HID Global Corporation
procedure to access the
L000950 Rev 1.8 245