Using The Mag Hi-Co Voltage Offset Option; Using The Mag Lo-Co Voltage Offset Option; Using The Mag Flipper Angle Offset Option; Using The Lamination Top Of Form Option - HID HDP5000 User Manual

All rights reserved HID Global Corporation

Using the Mag Hi-Co Voltage Offset Option

This option changes the voltage going the magnetic head.
This is factory set and should not be changed unless directed by a technician.

Using the Mag Lo-Co Voltage Offset Option

This option changes the voltage going the magnetic head.
This is factory set and should not be changed unless directed by a technician.

Using the Mag Flipper Angle Offset Option

This option changes the angle of the Flipper Table. Increasing the flipper angle will rotate
the flipper table clockwise. This is factory set and should not be changed unless directed by
a technician.

Using the Lamination Top of Form Option

This option changes location of patch(s) over length of card

Using the Lamination End of Form Option

This option changes head lift at end of card

Using the Lamination Bottom Takeup Option

This option changes tension of Laminate roll 1.

Using the Lamination Top Takeup Option

This option changes tension of Laminate rolls 2 (if equipped)
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8 297