Adjusting The Transfer Dwell Time And Temperature - HID HDP5000 User Manual

All rights reserved

Adjusting the Transfer Dwell Time and Temperature

Use the Image Transfer option to control of the Transfer Dwell Time and Transfer
Temperature.
•
These settings control the speed and temperature at which printed images are
transferred from the HDP Film to the card. These settings may vary depending on the
card type.
•
The Printer Driver automatically optimizes these settings according to the selection made
in the Card Type option.
•
Changes made to the Dwell Time and temperature settings are saved for the selected
Card Type option (upon exiting the Printer Driver setup in the Printer's Control Panel).
Step Procedure
1 Transfer Dwell Time Sets dwell time for InTM transfer in seconds per inch
Lower limit = 1.0 seconds per inch, Upper limit = 3.0 seconds per inch
•
UltraCard III - Composite: Default = 2.0 seconds per inch
•
UltraCard - PVC: Default = 2.0 seconds per inch
•
Custom: Default = 2.0 seconds per inch
2 Transfer Temperature Sets temperature for InTM transfer in Celsius Lower
limit = 150.0 Celsius, Upper limit = 190.0 Celsius
•
UltraCard III - Composite: Default = 175.0 seconds per inch
•
UltraCard- PVC: Default = 175.0 Celsius
•
Custom: Default = 175.0 Celsius
HDP5000 High Definition Card Printer/Encoder User Guide
HID Global Corporation
L000950 Rev 1.8 110