All rights reserved
Replacing or Cleaning the FAN foam filter
Step
Process
1
Grasp the top of the Inlet Fan Cover and pull OUT then UP to release the tabs
holding the bottom of the Inlet Fan Cover.
2
Remove the Foam Fan Filter Insert to replace or clean.
Clean with water and be sure the foam is dry before replacing into printer.
3
Replace the Inlet Fan Cover by fitting the bottom tabs in first then clicking the
top in place.
4
You have completed this procedure.
HDP5000 High Definition Card Printer/Encoder User Guide
HID Global Corporation
L000950 Rev 1.8
308