Card Lamination Module; Printer Unit: Reviewing The Card Lamination Module; Figure 26 - Adjusting Lamination Module - HID HDP5000 User Manual

5

Card Lamination Module

The Printer supports the attachment of an optional Card Lamination Module. Select Printer
Models Support for the attachment of an optional Card Lamination Module. This Module can
be ordered pre-installed or separate as a field upgradeable Module.
Once attached, the Card Lamination Module allows you to apply certified overlaminates for
more secure, tamper-resistant cards. This section explains all aspects of the Card Lamination
Module's operation and the overlaminate materials available.
5.1

Printer Unit: Reviewing the Card Lamination Module

WARNING: The Printer's Transfer Roller reaches temperatures exceeding
350° F (175° C). Use extreme caution when operating the Laminator.
Never touch the Transfer Roller unless the Printer has been turned off for
at least 20 minutes.
5.1.1 Adjusting the Lamination Placement on the Card
The Card Lamination Module provides an adjustable Lamination Placement knob that allows
you to fine-tune where the lamination is being placed on the card.

Figure 26 - Adjusting Lamination Module

Step Procedure
1
• The Lamination Placement Adjustment Knob is the light gray knob to the right of the Lamination
Cartridges.
• The printer will have one or two film cartridges loaded (depending on whether this is a Single or
Dual-Side Lamination Module).
2 Print a test card to see if the Lamination needs to be adjusted.
• Turn the knob to the right (the negative sign) to move the patch toward the front edge of the
Lamination Module. Turn the knob to the left (the positive sign) to move the patch toward the back
edge of the lamination module.
• Refer to the instruction diagram label located on the open front cover to make this adjustment.
Page 82 of 101
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
© 2012, 2013 HID Global Corporation. All rights reserved
July 2013