Installing The Card Output Hopper; Connecting Power To Hdp8500 Printer And/Or Lamination Module - HID Fargo HDP8500 User Manual

© 2012 HID Global Corporation. All rights reserved.

Installing the Card Output Hopper

Step Procedure
1 Unlock and place the card output hopper onto the output side ( left) of the
printer and push down until it clicks into place.
Connecting Power to HDP8500 Printer and/or Lamination
Module
Important! Do not plug in the USB cable until prompted to do so during the installation of the
HDP8500 Printer Driver. Refer to the Driver installation procedure below.
Step Procedure
1 Insert the power cord into the Printer as shown below.
2 Use the ON/Off switch to power up and down. This powers up both the Printer and the
Lamination Module.
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
53