Installing The Card Lamination Module; Introduction; Inspecting The Card Lamination Module; Unpacking The Card Lamination Module - HID HDP5000 User Manual

All rights reserved

Installing the Card Lamination Module

Introduction

The following guide provides a step-by-step installation procedure for the HDP5000
Lamination Module and Printer Driver Accessory. Refer to the HDP5000 High Definition Card
Printer/Encoder User Guide for details on operating your new card Lamination Module.
The time required for each installation is provided below:
• Lamination Module Installation (time required): This hardware installation process will
require approximately 10 to 15 minutes.
• Driver Software Installation (time required): This software installation process will
require approximately 2 to 6 minutes (depending on the speed of your PC).

Inspecting the Card Lamination Module

While unpacking your Lamination Module, inspect the carton to ensure that no damage has
occurred during shipping. (Note: Make sure that all supplied accessories are included with
your unit.)
Your new Lamination Module is packaged in a standard HDP5000 Card Printer/Encoder
carton. (Note: It is recommended that you save the packaging in the event that you need to
transport the Card Printer/Encoder/Laminator at a future date.)

Unpacking the Card Lamination Module

The following items are included with your new Lamination Module:
•
Card Lamination Module
•
Power Supply with a Power Cord (for the Card Lamination Module)
•
Warranty Card
Choosing a proper Locatio
Follow these guidelines:
•
Place the unit in a location with adequate air circulation to prevent internal heat build-up.
•
Use the Printer's dimensions (10.75 H x 35.5 W x 13 D) as a guideline for the minimum
clearances to the unit. (Note: Allow for adequate clearance above the unit to
accommodate the height of the unit with its Covers open.)
•
Do not install the unit near heat sources, such as, radiators or air ducts.
•
Do not install the unit in a place subject to direct sunlight, excessive dust, mechanical
vibration or shock.
HDP5000 High Definition Card Printer/Encoder User Guide
n
L000950 Rev 1.8
HID Global Corporation
263