Choosing A Good Location; About Moisture Condensation - HID HDP5000 User Manual

All rights reserved

Choosing a Good Location

Follow these guidelines:
•
Place the unit in a location with adequate air circulation to prevent internal heat build-up.
•
Use the Printer's dimensions as a guideline for the minimum clearances to the unit.
(Note: Allow for adequate clearance above the unit to accommodate the height of the
unit with its Covers open.)
•
Do not install unit near heat sources such as radiators or air ducts or in a place subject to
direct sunlight, excessive dust, mechanical vibration or shock.

About Moisture Condensation

If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow
the moisture to evaporate.
Caution: For safety purposes, Ethernet is not intended for a direct connection
outside of the building.
HDP5000 High Definition Card Printer/Encoder User Guide
HID Global Corporation
L000950 Rev 1.8 41