Connecting A Wideband Power Sensor; Figure 1-11 Connecting The Sensor Cable To The 8990B - Keysight 8990B Installation Manual

Connecting a Wideband Power Sensor

Connect the sensor cable to the 8990B RF input channel as shown in the
following figure. Ensure that you align the red dots on the sensor cable and the
8990B connector.
Figure 1-11
Allow a few seconds for the 8990B to read the data contained in the sensor
EEPROM and perform automatic zeroing of the sensor.
– Ensure that the sensor cable is attached and removed in an indoor
NOTE
– The 8990B performs internal zeroing and calibration routines on the sensor.
– The 8990B User's Guide explains in more detail the methods used to perform
Keysight 8990B Installation Guide
Connecting the sensor cable to the 8990B
environment.
The process used for this internal zeroing and calibration is explained in the
N1921/2A Operating and Service Guide and N1923/4A User's Guide.
the zeroing and calibration of the sensor.
Getting Started
41
1