Panasonic KX-NS1000 Programming Manual page 605

11.5.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—Group Settings
PC Programming Manual References
12.1.2 PBX Configuration—[4-1-2] Extension—Wired Extension—FWD/DND
12.2.2 PBX Configuration—[4-2-2] Extension—Portable Station—FWD/DND
Feature Guide References
2.2.2.2 Group Call Distribution
Tenant Number
Specifies the tenant to which the incoming call distribution group belongs, to determine the Time Table and
the audio source for the group. (The tenant number corresponds to the Time Table number.)
Value Range
1–32 or 1–128
Note
The maximum number of tenants depends on the System Capacity Selection setting made when the
Easy Setup Wizard was run for the PBX. If the System Resource Type was selected, the maximum
number of tenants is 128. If the Standard Type or IP-Extension Type was selected, the maximum number
of tenants is 32. For details, refer to "5.4.1 Easy Setup Wizard" in the Installation Manual.
Maintenance Console Location
11.5.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—Group Settings
PC Programming Manual References
10.2 PBX Configuration—[2-2] System—Operator & BGM
10.4 PBX Configuration—[2-4] System—Week Table
14.6 PBX Configuration—[6-6] Feature—Tenant—
Feature Guide References
2.13.4 Music on Hold
5.1.3 Tenant Service
COS
Specifies the COS of the incoming call distribution group. Depending on the COS, calls from certain extensions
are restricted as determined by the Internal Call Block feature. Also, when calls are forwarded or overflowed
to a trunk, the TRS/Barring assigned for the COS of the incoming call distribution group applies.
Value Range
1–512
Maintenance Console Location
11.5.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—Group Settings
Music On Hold
PC Programming Manual 605