Pbx Configuration—[11-3] Maintenance—Power Failure Transfer - Panasonic KX-NS1000 Programming Manual

19.3 PBX Configuration—[11-3] Maintenance—Power Failure Transfer
19.3 PBX Configuration—[11-3]
Maintenance—Power Failure Transfer
Notice
This screen is for programming legacy gateway PBXs. For information about setting up a legacy gateway
PBX, see 9.29 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2.
For information about programming Power Failure Transfer settings, refer to the corresponding
Maintenance—Power Failure Transfer section in the PC Programming Manual of the legacy gateway PBX.
The following programming items are specific to the KX-NS1000 Web Maintenance Console.
Using the Site selection drop-down list, select the site where the legacy gateway PBX is connected, and then
programme the settings.
Shelf
Specifies the legacy gateway PBX shelf (reference only).
Value Range
2: Legacy-GW1
3: Legacy-GW2
Maintenance Console Location
19.3 PBX Configuration—[11-3] Maintenance—Power Failure Transfer
PC Programming Manual References
9.29 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2
PFT Card Position
Specifies the position of the card(s) with power failure transfer ports (reference only).
Note
The number of available PFT cards and PFT ports depends on the model of the legacy gateway PBX. For
details, refer to the documentation for the legacy gateway PBX.
Value Range
Pair - 1–Pair - 12
Maintenance Console Location
19.3 PBX Configuration—[11-3] Maintenance—Power Failure Transfer
860 PC Programming Manual