Panasonic KX-NS1000 Programming Manual page 1027

WAN Port End
Specifies the end port for the WAN port range. If this setting is blank, only the port set for
is available for port forwarding.
If ICMP is selected for
Note
•
If neither the start port nor the end port is set, any port can be used.
•
The user cannot reserve system ports for the WAN side.
•
If a range is set, ensure that the number of internal ports and external ports match each other.
•
Ensure that the end range value is greater than the start range value.
Value Range
1–65535
Maintenance Console Location
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
Local IP Address
Specifies the IP address of equipment on the LAN.
Value Range
1.0.0.1–223.255.255.254
Maintenance Console Location
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
LAN Port Start
Specifies the start port for the LAN port range.
If ICMP is selected for
Note
•
If neither the start port nor the end port is set, any port can be used.
•
The user cannot reserve system ports for the WAN side.
•
If a range is set, ensure that the number of internal ports and external ports match each other.
Value Range
1–65535
Maintenance Console Location
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
LAN Port End
Specifies the end port for the LAN port range.
If this setting is blank, only the port set for
If ICMP is selected for
Protocol, this item is greyed out.
Protocol, this item is greyed out.
LAN Port Start is available for port forwarding.
Protocol, this item is greyed out.
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
WAN Port Start
PC Programming Manual 1027