Message Waiting Lamp - Panasonic KX-NS1000 Programming Manual

Message Waiting Lamp

If set to "Enable", the Message Waiting Lamp of the subscriber's telephone turns on when a new message is
recorded.
Value Range
Disable, Enable
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.30 Message Waiting Notification—Lamp
Telephone Device
Specifies the Message Waiting Notification schedule for each device. The following parameters can be
specified for devices 1, 2, and 3. Click Edit for the extension to change, set Device Notification for
Unreceived Message to "Yes", and programme the settings, then click OK to finish.
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.31 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Notification Type
Specifies the type of message for which notification is sent. Notification can be sent for all messages, or voice
messages or fax messages only.
Value Range
All Messages, Voice Messages, Fax Messages
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.31 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Only Urgent Messages
Specifies if notifications will be sent only for messages designated as urgent.
Value Range
Yes, No
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
PC Programming Manual 873