Panasonic KX-NS1000 Programming Manual page 814

18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Distribution Method
Selects the distribution method for incoming trunk calls. The value range of this setting depends on the card
type and Trunk Property assigned for each trunk.
Value Range
DIL: Distribution depends on the trunk through which the calls arrive
DDI/DID: Distribution depends on the DDI/DID number of the calls
MSN: Distribution depends on the MSN of the calls
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Guide References
2.1.1.1 Incoming Trunk Call Features—SUMMARY
DIL Destination—Day, Lunch, Break, Night
Specifies the DIL destination in each time mode.
Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
Feature Guide References
2.1.1.2 Direct In Line (DIL)
4.3.1 TIE Line Service
Tenant Number
Specifies the tenant number, to determine the Time Table by which calls are distributed depending on the time
of day.
Value Range
1–32 or 1–128
Note
The maximum number of tenants depends on the System Capacity Selection setting made when the
Easy Setup Wizard was run for the PBX. If the System Resource Type was selected, the maximum
number of tenants is 128. If the Standard Type or IP-Extension Type was selected, the maximum number
of tenants is 32. For details, refer to "5.4.1 Easy Setup Wizard" in the Installation Manual.
814 PC Programming Manual