Pulse Speed - Panasonic KX-NS1000 Programming Manual

CPC Signal Detection Time—Outgoing, Incoming
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming trunk calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC
signal is not detected.
Value Range
None, 6.5 ms, 8 ´ n (n=1–112) ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Feature Guide References
2.11.9 Calling Party Control (CPC) Signal Detection
DTMF Width
Selects the length of the DTMF tone sent to the analogue trunk.
Value Range
80 ms, 160 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port

Pulse Speed

Selects the speed at which pulse dials are sent to the analogue trunk.
Value Range
Low, High
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Reverse Detection
Selects the type of trunk call for which the reverse signal from the telephone company is detected.
Value Range
Disable: For no trunk call
Outgoing: For outgoing trunk calls only
Both Call: For both outgoing and incoming trunk calls
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
PC Programming Manual 397