Panasonic KX-NS1000 Programming Manual page 796

16.5 PBX Configuration—[8-5] ARS—Carrier
TRG 01–TRG 96
Selects the trunk groups that connect to the carrier.
TRG 01–TRG 96
Enables each trunk group for each carrier. If a cell is highlighted in blue, that trunk group is enabled for use
with that carrier.
Value Range
OFF (white), ON (blue)
Maintenance Console Location
16.5 PBX Configuration—[8-5] ARS—Carrier
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
Authorisation Code for Tenant
Specifies an Authorisation code for each tenant. The Authorisation codes can be added to the user-dialled
number by specifying "A" command in
Authorisation Code for Tenant—Tenant 1–Tenant 32/Tenant 128
Specifies the Authorisation code of each carrier for each tenant.
Note
The maximum number of tenants depends on the System Capacity Selection setting made when the
Easy Setup Wizard was run for the PBX. If the System Resource Type was selected, the maximum
number of tenants is 128. If the Standard Type or IP-Extension Type was selected, the maximum number
of tenants is 32. For details, refer to "5.4.1 Easy Setup Wizard" in the Installation Manual.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Maintenance Console Location
16.5 PBX Configuration—[8-5] ARS—Carrier
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
5.1.3 Tenant Service
796 PC Programming Manual
Modify Command on the Carrier tab.