Panasonic KX-NS1000 Programming Manual page 375

Gain Type
Specifies the type of gain file to distribute to connected SIP devices.
Value Range
Default, Type1, Type2, Type3
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
Secondary Setting
The settings on this screen are for programming the Automatic Rerouting to Secondary PBX feature for use
among IP extensions in a networked environment. For details and conditions regarding the use of this feature,
refer to "4.2.3.2 Automatic Rerouting to Secondary PBX" in the Feature Guide.
Setting Secondary Ports
Follow the steps below to designate secondary ports for IP extensions.
1.
Specify the secondary ports.
a.
Access the port property screen of the site where the ports will be set as secondary ports.
b.
In Primary/Secondary, set the unused ports that will be used as secondary ports to "Secondary".
Note
Ports that have already been registered (A value other than the default of "00:00:00:00:00:00" is
set for
"Secondary" here.
2.
Access the port property screen of the site where primary ports will be assigned secondary ports.
3.
Click Set Secondary. A dialogue box will appear.
4.
From the drop-down list, select a site where secondary ports will be assigned.
Note
The number displayed for Available ports indicates the maximum number of available ports at the
selected site that can be registered as secondary ports.
5.
Extensions' primary ports and names are displayed on the left. Select the extensions for which to want to
register secondary ports, and then click the right arrow.
Note
Ports that are already assigned as secondary ports will not be displayed in this list.
6.
Click Execute. A message confirming the registration will be displayed.
7.
Repeat steps 2–6 for each site where you want to designate secondary ports.
Removing Secondary Port Settings
Follow the steps below to remove secondary port settings for IP extensions.
1.
Click Remove Secondary. A dialogue box will appear.
2.
Primary ports of extensions that have secondary ports assigned are displayed on the left. Select the
extensions whose secondary setting you want to remove, and then click the right arrow.
3.
Click Execute. A message confirming the setting removal will be displayed.
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
IP Phone Registration ID (MAC Address) on the Main tab) cannot be set to
PC Programming Manual 375