Utility—Command - Panasonic KX-NS1000 Programming Manual

7.8.2 Utility—Command—Router Command
7.8 Utility—Command
7.8.1 Utility—Command—UM Command
System commands can be sent directly to the Unified Messaging system using the Commands dialogue.
This screen can be accessed only in On-line mode.
Follow the steps below to use the Commands dialogue:
1.
Enter the desired command, then click RUN. Results from entered commands are displayed.
2.
When finished, click Close.
7.8.2 Utility—Command—Router Command
Router commands can be sent directly to the built-in router using the Commands dialogue.
This screen can be accessed only in On-line mode.
Follow the steps below to use the Commands dialogue:
1.
Enter the desired command, then click RUN. Results from entered commands are displayed.
2.
When finished, click Close.
Note
•
Some examples of supported commands are as follows: ROUTE, NETSTAT, ARP, DNSFLUSH.
154 PC Programming Manual