Panasonic KX-NS1000 Programming Manual page 822

18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
UM Service Group No.
Specifies the Service Group number sent to the Unified Messaging system when the incoming call destination
is the floating extension number of a UM group.
The Service Group number is used to allow the Unified Messaging system to send the applicable greeting
message to the caller.
Value Range
None, 1–64
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
3.1.1 Unified Messaging System Overview
VM Trunk Group No.
Specifies the number of the VM trunk group sent to the VPS when the incoming call destination is the floating
extension number of a VM (DPT) Group (connected to a KX-NCP/KX-TDE series PBX). The VM trunk group
number is used to allow the VPS to send the applicable greeting message to the caller.
Value Range
1–48
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
CLI Ring for DDI/DID—Day, Lunch, Break, Night
Enables CLI distribution in each time mode.
Value Range
Disable, Enable
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
PC Programming Manual References
14.1 PBX Configuration—[6-1] Feature—System Speed Dial
Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
2.1.1.5 Calling Line Identification (CLI) Distribution
822 PC Programming Manual