Panasonic KX-NS1000 Programming Manual page 290

9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
FAX Sending Method
Specifies the method of transporting the fax signal.
Value Range
G.711 Inband, T.38
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
Maximum Bit Rate
Specifies the maximum bit rate of the fax signal.
Value Range
No Speed Limit, 2400 bps, 4800 bps, 7200 bps, 9600 bps, 12000 bps, 14400 bps
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
FAX Detection Ability
Enables the use of the FAX Detection Ability feature. This feature enables end-to-end fax signal relay when
the other party prefers a codec other than G.711. This feature functions only if the other party supports G.711.
Value Range
Disable, Enable
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
DTMF
Specifies the method to transport DTMF tones.
Value Range
Inband, Outband (RFC2833), Outband (SIP INFO)
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
Payload Type
Specifies the payload type of RFC2833 for DTMF tones.
Note
Manual programming is required if DTMF is set to Outband (RFC2833).
290 PC Programming Manual