Pbx Configuration—[1-1] Configuration—Slot—Legacy-Gw1/Legacy-Gw2—Card Property - Opb3 - Panasonic KX-NS1000 Programming Manual

9.29.1 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2—Card Property - OPB3
9.29.1 PBX Configuration—[1-1]
Configuration—Slot—Legacy-GW1/Legacy-GW2—Card Property
- OPB3
The properties of the optional base card (OPB3) installed in a legacy gateway can be specified.
OPB3 Option Card Setup
OPB3 option card setup is available in Off-line mode only.
1.
Add the OPB3 card to the legacy gateway. For details, see To install a new physical card in a legacy
gateway in 9.29 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2.
2.
Move the mouse pointer over the installed OPB3 card on the legacy gateway Slot screen. A menu will be
shown under the mouse pointer. Select Option Card.
3.
Select a slot number, and click the right and left arrow buttons (">", "<") to add or remove option cards from
the currently selected slot. Click OK when finished. For details about the option cards that can be used
with each legacy gateway PBX, refer to the documentation of the legacy gateway PBX.
OPB3 Card Properties
The properties of the Optional Base card can be specified.
Move the mouse pointer over the installed OPB3 card on the legacy gateway Slot screen. A menu will be shown
under the mouse pointer. Select Card Property.
Unless noted otherwise, the programming information is the same as described in the PC Programming Manual
of the legacy gateway PBX. Refer to the corresponding Slot—Card Property - OPB3 section in the PC
Programming Manual of the legacy gateway PBX for more information.
The following programming items are specific to when programming legacy gateways using Web Maintenance
Console:
Shelf
Indicates the shelf position of the KX-NS1000 for the legacy gateway in which the OPB3 card is installed
(reference only).
Value Range
2: Legacy-GW1
3: Legacy-GW2
Maintenance Console Location
9.29.1 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2—Card Property - OPB3
Port Status
Indicates the port status for installed option cards. To change the status of the port, click the desired cell in the
column, and then select INS or OUS for the port.
This option is only available in On-line mode.
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: There is a communication error.
436 PC Programming Manual