Panasonic KX-NS1000 Programming Manual page 369

Value Range
Max. 20 characters
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
Feature Guide References
5.2.2 SIP (Session Initiation Protocol) Extension
Telephone Type
Specifies the connected device type.
Note
•
This setting cannot be changed if a device has already been registered for the port. De-register the
device set for the port before changing the setting.
•
To change this setting when programming in Off-line mode, and a device is already registered to the
port, change the setting of
"00:00:00:00:00:00", and then click Apply. The setting can then be changed.
Value Range
UT: A KX-UT series SIP phone is connected.
S-PS: A SIP Portable Station phone is connected.
SIP-CS: A SIP Cell Station is connected.
Master-CS: A SIP Master Cell Station is connected.
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
Feature Guide References
5.2.2 SIP (Session Initiation Protocol) Extension
Connection
Indicates the port status. To change the status of the port, click the desired cell in the column, and then select
INS or OUS for the port.
This option is only available in On-line mode.
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
IP Phone Registration ID (MAC Address) for the port to
PC Programming Manual 369