Panasonic KX-NS1000 Programming Manual page 815

Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Guide References
2.1.1.2 Direct In Line (DIL)
5.1.3 Tenant Service
5.1.4 Time Service
UM Service Group No.
Specifies the Service Group number sent to the Unified Messaging system when the incoming call destination
is the floating extension number of a UM group.
The Service Group number is used to allow the Unified Messaging system to send the applicable greeting
message to the caller.
Value Range
None, 1–64
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Guide References
2.1.1.2 Direct In Line (DIL)
3.2.1 System Features—3.2.1.40 Service Group
VM Trunk Group No.
Specifies the number of the VM trunk group sent to the VPS when the incoming call destination is the floating
extension number of a VM (DPT) Group (connected to a KX-NCP/KX-TDE series PBX). The VM trunk group
number is used to allow the VPS to send the applicable greeting message to the caller.
Value Range
1–48
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
CLI for DIL
When CLI distribution is enabled for a trunk to which DIL distribution is set, incoming trunk calls will be
distributed to the CLI destinations (instead of the DIL destinations) if the caller's identification number is found
in the System Speed Dialling Table.
CLI distribution can be enabled or disabled for each time mode (day/lunch/break/night) on a trunk basis.
The Site, Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
PC Programming Manual 815