Panasonic KX-NS1000 Programming Manual page 1082

28.1 Network Service—[1] IP Address/Ports
DNS Setting—Obtain DNS server address automatically/Use the following DNS
server address
Specifies whether to enable the DHCP server to assign DNS server address information automatically to the
mother board, or to enter the information manually.
Value Range
Obtain DNS server address automatically, Use the following DNS server address
Maintenance Console Location
28.1 Network Service—[1] IP Address/Ports—Basic Settings
Feature Guide References
5.6.6 Dynamic Host Configuration Protocol (DHCP) Assignment
DNS Setting—Preferred DNS IP Address
Specifies the preferred IP address for the DNS server. This parameter is only available for entering values
when Use the following DNS server address is selected.
Note
•
Since communication over a VPN will not be possible, do not set a destination IP address in the VPN
for this setting.
•
If this setting is configured at the same time as the following settings, this setting takes precedence.
–
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings—Static IP—
DNS IP Address
–
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings—DHCP—
DNS IP Address
–
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings—PPPoE—
DNS IP Address
Value Range
1.0.0.0–223.255.255.255
Maintenance Console Location
28.1 Network Service—[1] IP Address/Ports—Basic Settings
PC Programming Manual References
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
Installation Manual References
8.6.5 DNS Client
DNS Setting—Alternative DNS IP Address
Specifies the alternative IP address for the DNS server. This parameter is only available for entering values
when Use the following DNS server address is selected.
1082 PC Programming Manual
Preferred
Preferred
Preferred