Panasonic KX-NS1000 Programming Manual page 1045

Note
If TCP or TCP&UDP is selected for Protocol Number—Protocol Name, the default value is FTP. If
UDP is selected for Protocol Number—Protocol Name, the default value is DNS.
Value Range
If TCP is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
FTP(20/21), SSH(22), Telnet(23), HTTP(80), HTTPS(443), POP3(110), POS3S(995), IMAP(143), SMTP(25)
If UDP is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
DNS(53), DHCP(67/68), TFTP(69), SNMP(161/162)
If TCP&UDP is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
FTP(20/21), SSH(22), Telnet(23), HTTP(80), HTTPS(443), POP3(110), POS3S(995), IMAP(143), SMTP(25),
DNS(53), DHCP(67/68), TFTP(69), SNMP(161/162)
Maintenance Console Location
27.8 Router Configuration—Firewall—[2-2] Packet Filtering
Filter—TCP/UDP Destination Port—Port Number
Specifies the start and end port number.
If ICMP is selected for Protocol Number—Protocol Name, this item is greyed out.
Value Range
0–65535
Maintenance Console Location
27.8 Router Configuration—Firewall—[2-2] Packet Filtering
Filter—Source
Selects the method of specifying the source packet.
Value Range
ANY, Address, Subnet
Maintenance Console Location
27.8 Router Configuration—Firewall—[2-2] Packet Filtering
Filter—Source—IP Address
Specifies the IP address.
If ANY is selected for Source, this item is greyed out.
Value Range
Blank, 1.0.0.1–223.255.255.254
27.8 Router Configuration—Firewall—[2-2] Packet Filtering
PC Programming Manual 1045