Panasonic KX-NS1000 Programming Manual page 1017

Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
LCP ECHO—LCP Echo Interval (s)
Specifies the LCP Echo Interval in seconds.
This value sets the interval between LCP echo requests sent by the PBX to the ISP.
If LCP ECHO is not selected for 27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection
Settings—PPPoE —
Value Range
1–3600 s
Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
LCP ECHO—LCP Echo Retries
Specifies the number of times that the PBX tries to get a response to an LCP echo request before the PPPoE
connection is considered inactive.
If LCP ECHO is not selected for 27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection
Settings—PPPoE —
Value Range
1–255
Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
LCP ECHO—PPPoE Recovery Time
Specifies the number of times that the PBX is judged to be recovered after the PPPoE connection has been
re-established.
If LCP ECHO is not selected for 27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection
Settings—PPPoE —
Value Range
1–255
Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
TCP MSS
Selects the setting method of the TCP MSS (Maximum Segment Size) value.
This function is only available for IPv4 packets.
–
Auto: MTU-40 is specified.
–
Fixed: Specifies the TCP MSS Value.
If Auto is selected, MTU-40 is specified. However if MTU is smaller than MRU, MRU-40 is specified.
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
PPP Keep-Alive, this item is greyed out.
PPP Keep-Alive, this item is greyed out.
PPP Keep-Alive, this item is greyed out.
PC Programming Manual 1017