Panasonic KX-NS1000 Programming Manual page 874

20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.31 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Dial Number [0-9 * # T X , ;]
Assigns a telephone number to Device 1, 2, or 3. The subscriber can also specify the number to be dialled by
entering it from his or her telephone, allowing the subscriber to set this feature on a case by case basis.
Note
When the Unified Messaging system calls a trunk via the PRI card, be sure to add "#" after the telephone
number (1112223333 in the example here): 9P1112223333#PP123PP456PPX# (P: Dial Pause)
Value Range
Max. 32 digits consisting of 0–9,
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
T: Dial Tone Detection
X: Callback Number Entry Code
0–9, , #: Dial Code
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.31 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—No. of Retries
Specifies the number of times the Unified Messaging system will try to send notification if the device is busy
or if there is no answer.
Value Range
0–9 times
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.31 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Busy Delay Time (min)
Specifies the time (in minutes) the Unified Messaging system waits before retrying message notification when
the called device is busy.
874 PC Programming Manual
, # and special codes: