27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
Note
•
If neither the start port nor the end port is set, any port can be used.
•
The user cannot reserve system ports for the WAN side.
•
If a range is set, ensure that the number of internal ports and external ports match each other.
•
Ensure that the end range value is greater than the start range value.
Value Range
1–65535
Maintenance Console Location
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
Protocol Setting
ICMP (WAN/LAN)—Send ICMP Redirect
Selects whether to send ICMP redirect messages.
Value Range
Enable, Disable
Maintenance Console Location
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
ICMP (WAN/LAN)—Allow ICMP Redirect
Selects whether to enter a new IP address in the routing table in accordance with ICMP redirect message.
Value Range
Enable, Disable
Maintenance Console Location
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4
1028
PC Programming Manual