Pbx Configuration—[1-1] Configuration—Slot—Legacy-Gw1/Legacy-Gw2 - Panasonic KX-NS1000 Programming Manual

9.29 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2
9.29 PBX Configuration—[1-1]
Configuration—Slot—Legacy-GW1/Legacy-GW2
Settings for PBXs connected to the KX-NS1000 over a stacking connection can be programmed. Click
Legacy-GW1 or Legacy-GW2 on the Slot screen to view the physical card shelf of the legacy gateway.
Note
•
Legacy gateways must first be pre-installed before they can be programmed. For details, see To
pre-install PBXs connected to the STACK-M card in 9.1 PBX Configuration—[1-1]
Configuration—Slot.
•
For information about hardware configuration restrictions and conditions for legacy gateways, refer to
Conditions for Connecting Legacy Gateways in 4.6 Stacking Cards in the KX-NS1000 Installation
Manual.
To install a new physical card in a legacy gateway
1.
Click on the name of the card to install in the list on the right. An image of the card will be displayed, and
information about the card will be shown.
2.
Click and drag the image of the card to the slot, and release it. The card will move into the slot space.
3.
Click OK to confirm.
To change the status (INS/OUS) of a legacy gateway
1.
Move the mouse pointer over the Shelf Status button. A menu will be shown under the mouse pointer.
2.
Select the desired status:
•
Click INS to set the shelf to in-service status.
•
Click OUS to set the shelf to out-of-service status.
To remove a legacy gateway from the STACK-M card
1.
Move the mouse pointer over the Shelf Status button. A menu will be shown under the mouse pointer.
2.
Click Delete. The legacy gateway will be deleted from the system and the corresponding shelf button will
become greyed out.
Note
The legacy gateway must be set to OUS before it can be deleted.
Programming cards installed in a legacy gateway
You can access the card properties and port properties of the physical cards installed in a legacy gateway
using the KX-NS1000 Web Maintenance Console Interface. The settings, setting values, and other information
is similar to programming using the Unified PC Maintenance Console. Refer to the PC Programming Manual
of the legacy gateway PBX for programming information.
Note
Unless noted otherwise, programming items and specifications for PBXs connected as legacy gateways
correspond to the following PBX software versions. When referencing the manuals of other PBXs, refer to
manuals matching these software versions.
•
KX-TDE: PMMPR/PGMPR Software File Version 4.1xxx or later
•
KX-NCP: PBMPR Software File Version 4.1xxx or later
•
KX-TDA: PMPR/PLMPR Software File Version 5.0000 or later
434 PC Programming Manual