Engine; Oil Change And Oil Filter Replacement - Can-Am Rally 200 Operator's Manual

ENGINE

Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at
the same time. Oil change should be
done with a warm engine.
WARNING
The engine oil can be very hot. In
order to avoid potential burns, do
not remove the engine drain plug
or the oil filter cover if the engine is
hot. Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the drain plug area.
Place a drain pan under the engine
drain plug area.
Unscrew drain plug.
V06C1WY
1. Oil drain plug
Allow enough time for oil to flow out
of oil filter.
Unscrew the oil filter cover.
1
_____________________
V06C04Y
Remove oil filter and replace with a
new filter.
NOTE: Check the cover O-ring and
change it if necessary.
Wipe out any oil spillage on engine.
Remove oil strainer plug then clean oil
strainer.
1
V06C1WZ
1. Oil strainer plug
To clean oil strainer, use a solvent then
dry with compressed air.
WARNING
Always wear eye protection and
gloves.
103