Oil Change And Oil Filter Replacement - Can-Am MAX 400 EFI Operator's Manual

vmo2008-019-034_a
TYPICAL — RH SIDE OF VEHICLE
1. Drain tube
vmo2008-019-021_a
1. Air filter housing
2. Drain tube
3. Clamp
NOTE: If vehicle is used in dusty area,
inspect more frequently than specified
in MAINTENANCE CHART.
If liquids/deposits are found, squeeze
and remove the clamp. Pull drain tube
out. and empty it.
CAUTION: Do not start engine
when liquids/deposits are found
in the drain tube.
When liquids/deposits are found, the
air filter must be inspected/dried/
replaced depending on its condition.
Remove air filter as explained in AIR
FILTER REMOVAL.
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at
the same time. Oil change should be
done with a warm engine.
_____________________
118
WARNING
The engine oil can be very hot. In
order to avoid potential burns, do
not remove the engine drain plug
or the filter cover if the engine is
hot. Wait until engine oil is warm.
Ensure vehicle is on a level surface.
On the right side of vehicle, remove
engine cover.
vmo2008-019-025_a
TYPICAL — RH SIDE OF VEHICLE
1. Engine cover
Remove dipstick.
CAUTION: Pay attention not to lose
the O-ring on dipstick.
RH SIDE OF ENGINE
1. Dipstick
2. O-ring