Excessive Punt Flow Trap Commands
lpts punt excessive-flow-trap penalty-timeout
To set the penalty timeout value for a protocol, use the lpts punt excessive-flow-trap penalty-timeout
command in Global Configuration mode. To restore the default penalty timeout value, use the no form of this
command.
lpts punt excessive-flow-trap penalty-timeout{trace| arp| icmp| dhcp| pppoe| ppp| igmp| ip| l2tp| all|
interface| information} timeout
no lpts punt excessive-flow-trap penalty-timeout{trace| arp| icmp| dhcp| pppoe| ppp| igmp| ip| l2tp| all|
interface| information}
Syntax Description
default
arp
icmp
dhcp
pppoe
ppp
igmp
ip
l2tp
Command Default
The default value in minutes is 15.
Command Modes
Global Configuration mode
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Sets the default penalty timeout for all protocols.
Sets the penalty timeout for the ARP protocol.
Sets the penalty timeout for the ICMP protocol.
Sets the penalty timeout for the DHCP protocol.
Sets the penalty timeout for the PPPoE protocol.
Sets the penalty timeout for the PPP protocol.
Sets the penalty timeout for the IGMP protocol.
Sets the penalty timeout for the IPv4 protocol.
Sets the penalty timeout for the L2TP protocol.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
lpts punt excessive-flow-trap penalty-timeout
Modification
This command was introduced.
5.2.x
257