Lease Proxy Client-Lease-Time - Cisco ASR 9000 Series Command Reference Manual

BNG DHCP Commands

lease proxy client-lease-time

To specify the lease limit each circuit id each interface, use the lease proxy client-lease-time command in
the DHCP IPv4 sub configuration mode. To disable the lease proxy client-lease-time, use the no form of this
command.
lease proxy client-lease-time value
no lease proxy client-lease-time value
Syntax Description
value
Command Default
If you set the default (no), then the lease proxy gets disabled.
Command Modes
DHCP IPv4 configuration
Command History
Release
Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When the binding is created, the client-lease-time is cached on a per-binding basis, thus, the changes to the
profile client-lease-time does not cause any impact to any existing bindings. However, changes are effective
only for subsequently created bindings.
Task ID
Task ID
ip-services
Examples
This is an example of configuring the lease proxy client-lease-time command in the DHCP IPv4 sub
configuration mode:
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
RP/0/RSP0/CPU0:router(config-dhcpv4)# profile myproxyprofile proxy
RP/0/RSP0/CPU0:router(config-dhcpv4)# lease proxy client-lease-time 600
Specifies the time in seconds for the lease proxy client. The minimum value of lease
proxy client-time is 600 seconds.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Modification
This command was introduced.
Operation
read, write
lease proxy client-lease-time
5.2.x
167