Cisco Asr 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference - Cisco ASR 9000 Series Command Reference Manual

show ipv4 interface (BNG)
Table 18: show ipv4 interface Command Field Descriptions
Field
Loopback0 is Up
line protocol is Up
Internet address
Secondary address
MTU
Multicast reserved groups joined
Directed broadcast forwarding
Outgoing access list
Inbound access list
Proxy ARP
ICMP redirects
ICMP unreachables
Internet protocol processing disabled
1 MTU = maximum transmission unit
2 ARP = Address Resolution Protocoladdress resolution protocol
3 ICMPv4 = Internet Control Message Protocol internet control message protocol version 4

Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,

Release 5.2.x
314
Description
If the interface hardware is usable, the interface is
marked "Up." For an interface to be usable, both the
interface hardware and line protocol must be up.
If the interface can provide two-way communication,
the line protocol is marked "Up." For an interface to
be usable, both the interface hardware and line
protocol must be up.
IPv4 Internet address and subnet mask of the
interface.
Displays a secondary address, if one has been set.
1
Displays the IPv4 MTU value set on the interface.
Indicates the multicast groups this interface belongs
to.
Indicates whether directed broadcast forwarding is
enabled or disabled.
Indicates whether the interface has an outgoing access
list set.
Indicates whether the interface has an incoming access
list set.
Indicates whether proxy ARP
on an interface.
3
Specifies whether ICMPv4
interface.
Specifies whether unreachable messages are sent on
this interface.
Indicates an IPv4 address has not been configured on
the interface.
IPv4 and IPv6 Commands
2
is enabled or disabled
redirects are sent on this