Cisco Asr 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference - Cisco ASR 9000 Series Command Reference Manual

Address Pool Service Commands
Each pool must have a unique name across all VRFs. For example, pool1 can not be created in both vrf1
Note
and vrf2.
Some pools can be associated with all the VRFs and these pools are configured with the all keyword.
Task ID
Task ID
ip-services
Examples This is an example of configuring the pool vrf command for IPv4 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv4 pool2
RP/0/RSP0/CPU0:router(config-pool-ipv4)#
This is an example of configuring the pool vrf command for IPv6 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv6 pool3
RP/0/RSP0/CPU0:router(config-pool-ipv6)#
Related Commands
Command
pool ipv4, on page 92
pool ipv6, on page 94
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Operation
read, write
Description
Enables distributed address pool service on IPv4.
Enables distributed address pool service on IPv6.
pool vrf
5.2.x
91