Ppp Timeout - Cisco ASR 9000 Series Command Reference Manual

BNG PPP Commands

ppp timeout

To configure timeouts for PPP protocol, use the ppp timeout command in the dynamic template configuration
mode. To disable this feature, use the no form of this command.
ppp timeout [ absolute absolute_minutes | authentication auth_seconds | retry retry_seconds ]
no ppp timeout
Syntax Description
absolute
authentication
retry
absolute_minutes
auth_seconds
retry_seconds
Command Default
None
Command Modes
Dynamic template configuration
Command History
Release
Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the dynamic-template command to enter the dynamic template configuration mode.
Task ID
Task ID
ppp
aaa
Specifies the absolute timeout for a PPP session.
Specifies the maximum wait time to receive an authentication response.
Specifies the maximum time to wait for a response during PPP negotiation.
Specifies the absolute timeout in minutes. This value ranges from
0-70000000.
Specifies the authentication wait time in seconds. This value ranges from
3-30.
Specifies the retry timeout in seconds. This value ranges from 1-10.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Modification
This command was introduced.
Operation
read, write
read, write
ppp timeout
5.2.x
395