Alarm And Alert Trap Configuration - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

▀ Alarm and Alert Trap Configuration

Alarm and Alert Trap Configuration
To enable and configure the SNMP Traps to generate alarms and alerts from system for various events and thresholds in
HNB-GW service, apply the following example configuration:
configure
snmp trap { enable | suppress} [congestion] {ThreshTotalHNBGWHnbSess |
ThreshTotalHNBGWIuSess | ThreshTotalHNBGWUeSess} [ target <trap_collector>]
snmp trap { enable | suppress} {ThreshTotalHNBGWHnbSess | ThreshTotalHNBGWIuSess |
ThreshTotalHNBGWUeSess} [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWALCAPNodeReset [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWALCAPPathBlock [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWALCAPPathReset [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWALCAPPathUnBlock [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWMSCRanapReset [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWSGSNRanapReset [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWServiceStart [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWServiceStop [ target <trap_collector>]
snmp trap { enable | suppress} HNBGWServiceStop [ target <trap_collector>]
end
Notes:
 There are several additional SNMP Traps which can be configured. Refer Global Configuration Mode chapter of
the Command Line Interface Reference for more information.
 For more information on SNMP Traps, refer System SNMP-MIB Reference.
 Repeat this configuration as needed for additional traps.
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
96
HNB-GW Service Configuration Procedures
OL-25069-03