Pppoe Sessions Throttle - Cisco ASR 9000 Series Command Reference Manual

pppoe sessions throttle

pppoe sessions throttle
To set a throttle value for the PPPoE sessions for a particular PPPoE BBA-Group, use the sessions throttle
command in PPPoE BBA-Group configuration mode. To remove the specified throttle value for PPPoE
sessions, use the no form of this command.
sessions {circuit-id| circuit-id-and-remote-id| inner-vlan| mac [access-interface]| mac-iwf access-interface|
outer-vlan| remote-id| vlan} throttle request-count request-period blocking-period
no sessions {circuit-id| circuit-id-and-remote-id| inner-vlan| mac [access-interface]| mac-iwf
access-interface| outer-vlan| remote-id| vlan} throttle request-count request-period blocking-period
Syntax Description
access-interface
circuit-id
circuit-id-and-remote-id
inner-vlan
mac
mac-iwf
outer-vlan
remote-id
vlan
throttle
request-count
request-period
blocking-period
Command Default
Sessions throttle is disabled by default.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
460
Throttles PPPoE sessions based on any one access
interface
Throttles PPPoE sessions with any one circuit-id.
Throttles PPPoE sessions by circuit-id and remote-id.
Throttles PPPoE sessions with any one inner-vlan id.
Throttles PPPoE sessions from any one mac address.
Throttles Inter-Working Function (IWF) sessions from
any one mac address.
Throttles PPPoE sessions with any one outer-vlan id.
Throttles PPPoE sessions with any one remote-id.
Throttles PPPoE sessions with matching vlan ids.
Specifies the action of throttling the PPPoE sessions
for various attributes.
Specifies the number of session requests allowed
before throttling.
Specifies the time interval during which the session
requests are counted.
Specifies the time interval during which no more
requests from the subscriber are accepted, when the
subscriber has already been throttled.
PPPoE Commands