Cisco ASR 9000 Series Command Reference Manual page 345

IPv4 and IPv6 Commands
Mcast: 0 received, 0 sent
ICMP statistics:
Rcvd: 0 input, 0 checksum errors, 0 too short
Sent: 0 output, 0 rate-limited
Neighbor Discovery ICMP statistics:
Rcvd: 0 router solicit, 0 router advert, 0 redirect
Sent: 0 router solicit, 0 router advert, 0 redirect
UDP statistics:
TCP statistics:s
This table describes the significant fields shown in the display.
Table 22: show ipv6 traffic Command Field Descriptions
Field
Rcvd:
total
local destination
source-routed
truncated
bad header
unknown option
unknown protocol
0 fragmented into 0 fragments, 0 failed
0 no route, 0 too big
0 unknown error type
unreach: 0 routing, 0 admin, 0 neighbor,
0 address, 0 port, 0 unknown
parameter: 0 error, 0 header, 0 option,
0 unknown
0 hopcount expired, 0 reassembly timeout,
0 unknown timeout, 0 too big,
0 echo request, 0 echo reply
unreach: 0 routing, 0 admin, 0 neighbor,
0 address, 0 port, 0 unknown
parameter: 0 error, 0 header, 0 option
0 unknown
0 hopcount expired, 0 reassembly timeout,
0 unknown timeout, 0 too big,
0 echo request, 0 echo reply
0 neighbor solicit, 0 neighbor advert
0 neighbor solicit, 0 neighbor advert
0 packets input, 0 checksum errors
0 length errors, 0 no port, 0 dropped
0 packets output
0 packets input, 0 checksum errors, 0 dropped
0 packets output, 0 retransmitted
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
show ipv6 traffic (BNG)
Description
Statistics in this section refer to packets received by
the router.
Total number of packets received by the software.
Locally destined packets received by the software.
Packets seen by the software with RH.
Truncated packets seen by the software.
An error was found in generic HBH, RH, DH, or HA.
Software only.
Unknown option type in IPv6 header.
Protocol specified in the IP header of the received
packet is unreachable.
5.2.x
331