Ipv6 Nd Ra-Initial - Cisco ASR 9000 Series Command Reference Manual

Neighbor Discovery Commands

ipv6 nd ra-initial

To set the IPv6 initial router advertisement count and interval, use the ipv6 nd ra-initial command in the
dynamic template configuration mode. To restore the default interval, use the no form of this command.
ipv6 nd ra-initial count interval
no ipv6 nd ra-initial
Syntax Description
value
interval
Command Default
None
Command Modes
Dynamic template configuration
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To enter the dynamic template configuration mode, run dynamic-template command in the Global
Configuration mode.
Task ID
Task ID
config-services
Examples This example configures an IPv6 router advertisement count of 5 and an interval of 201 seconds in the dynamic
template configuration mode:
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ipv6 nd ra-initial 5 201
The initial count or the initial number of the IPv6 router advertisements. The value
ranges from 0-32.
The interval (in seconds) between IPv6 router advertisement counts. The value
ranges from 4-1800.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Modification
This command was supported in the dynamic template configuration
mode for BNG.
Operations
read, write
ipv6 nd ra-initial
5.2.x
365