Configured Trap Receivers; Access Control - Cisco TELEPRESENCE ISDN GATEWAYS 2.0 Online Help Manual

Configured trap receivers

Field
Enable traps
Enable
authentication
failure trap
Trap receiver
addresses 1 to 4

Access control

Field
RO community
RW community
Trap community
Cisco TelePresence ISDN Gateways v2.0 Online help (Printable format)
Field description
Select this check box to enable the
ISDN gateway to send traps.
Select this check box to enable
authentication failure traps.
Enter the IP address or hostname for
up to four devices that will receive both
the general and the authentication
failure traps.
Field description
Community string/password that gives
read-only access to all trap
information.
Community string/password that gives
read/write access to all trap
information.
Community string/password that is
sent with all traps.
Configuring SNMP settings
Usage tips
If you do not check this box, no traps
will be sent.
You cannot select this check box unless
you have selected to Enable traps
above. Authentication failure traps are
generated and sent to the trap receivers
when someone tries to read or write a
MIB value with an incorrect community
string.
The traps that are sent by the ISDN
gateway are all SNMP v1 traps. You
can configure trap receivers or you can
view the MIB using a MIB browser. You
can set the UDP port number for the
trap in the format <IP address>: <port
number>. By default the UDP port
number is 162.
Usage tips
Note that SNMP community strings are
not secure. They are sent in plain text
across the network.
It is advisable to change the community
strings before enabling SNMP as the
defaults are well known.
Some trap receivers can filter on trap
community.
62 of 116