Qos Output Minimum-Bandwidth - Cisco ASR 9000 Series Command Reference Manual

qos output minimum-bandwidth

qos output minimum-bandwidth
To set the minimum guaranteed output bandwidth for a subscriber, use the qos output minimum-bandwidth
command in dynamic template configuration mode.
qos output minimum-bandwidth range
Syntax Description
range
Command Default
None
Command Modes
Dynamic template configuration
Command History
Release
Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance..
This command is available only in the dynamic template type ppp submode. The value specified in this
command is used only if IGMP HQoS correlation is configured. This is to ensure that the resultant bandwidth
does not go below the specified value.
Task ID
Task ID
vrrp
Examples This is an example of configuring the qos output minimum-bandwidth command in dynamic template
configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# qos output minimum-bandwidth 10
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
482
Specifies the minimum bandwidth range (1- 4294967295 kpbs).
Modification
This command was introduced.
Operation
read, write
QOS Commands