Cisco ASR 9000 Series Command Reference Manual page 412

show ppp interfaces (BNG)
Usage Guidelines
There are seven possible PPP states applicable for either the Link Control Protocol (LCP) or the Network
Control Protocol (NCP).
The command output displays a summary of the interface as it is in the PPP Interface Descriptor Block (IDB).
The output includes the following information (where applicable):
• Interface state
• Line protocol state
• Link Control Protocol (LCP) state
• Network Control Protocol (NCP) state
• Multilink PPP state
• Multilink PPP configuration
• Keepalive configuration
• Authentication configuration
• Negotiated MRUs
• Negotiated IP addresses
This command can display information for a single interface, all interfaces on a specified node, or all interfaces
on the router.
Task ID
Task ID
ppp
Examples This example shows how to display PPP state information for a POS interface:
RP/0/RSP0/CPU0:router# show ppp interface POS 0/2/0/3
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
398
POS0/2/0/3 is up, line protocol is up
LCP: Open
Keepalives enabled (10 sec)
Local MRU: 4470 bytes
Peer MRU: 4470 bytes
Authentication
Of Us: CHAP (Completed as 'test-user')
Of Peer: PAP (Completed as 'peer-user')
CDPCP: Listen
IPCP: Open
Local IPv4 address: 55.0.0.1
Peer IPv4 address:
Peer DNS Primary:
Peer DNS Secondary: 155.0.0.254
IPV6CP: Open
Local IPv6 address: fe80::3531:35ff:fe55:5747/128
Peer IPv6 address:
MPLSCP: Stopped
Operations
read
55.0.0.2
55.0.0.254
fe80::3531:35ff:fe55:4213/128
BNG PPP Commands