Prefix-Range - Cisco ASR 9000 Series Command Reference Manual

prefix-range

prefix-range
To specify a range of IPv6 address prefixes, use the prefix-range command in IPv6 configuration submode.
To remove the range of prefixes, use the no form of this command.
prefix-range {first_ipv6_range| last_ipv6_range}
no prefix-range {first_ipv6_range| last_ipv6_range}
Syntax Description
first_ipv6_range
last_ipv6_range
Command Default
None
Command Modes
Pool IPv6 configuration
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the pool ipv6 command to enter IPv6 pool configuration submode.
Multiple prefix-ranges are allowed within a pool. The length of the prefix in any pool is the same for all
prefix's and this is imposed by the prefix-length command. The prefix-length has to be mandatorily configured
whenever prefix-range is configured.
Task ID
Task ID
ip-services
Examples This is an example of configuring the prefix-range command in IPv6 configuration submode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv6 pool3
RP/0/RSP0/CPU0:router(config-pool-ipv6)# prefix-range 1001:1:1:1:: 1001:1:1:10::
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
88
Specifies the first IPv6 in the prefix range.
Specifies the last IPv6 in the prefix range.
Modification
This command was introduced.
Operation
read, write
Address Pool Service Commands