Show Subscriber Redundancy Group - Cisco ASR 9000 Series Command Reference Manual

Subscriber Commands

show subscriber redundancy group

To display the operational summary (including the active subscriber sessions under each subscriber redundancy
group (SRG) and the transient sessions awaiting synchronization to the peer) of all the configured SRGs, use
the show subscriber redundancy group command in the EXEC mode mode.
show subscriber redundancy group [group-id [session]] [location node-id]
Syntax Description
group
group-id
session
Command Default
None
Command Modes
EXEC
Command History
Release
Release 5.2.2
Usage Guidelines
The details listed under the show subscriber redundancy group command for a specific SRG include:
• Various applied operational parameters.
• Details of tracking objects registered on the SRG and their status. This shows if it is configured or not,
• Details about the peer that include the status of connection and info (for example, its tracking status and
• Details about switchover that include the last role change along with the reason, number of switchovers
• The active subscriber session statistics and any pending updates or deletions to be sent to the peer.
• The session entries that experienced failures in synchronization with the peer. Generally, this may be
Displays the summary information of all SRGs.
Displays the detailed information of a specific SRG.
Displays the key information about the sessions active under the SRG.
if it is set in the SRG but unknown because the tracking object is not configured and shows the current
status of object as reported.
roles) that it provided to this router in the previous negotiation, the timestamp of last negotiation and
the time when the peer went up or down.
and information regarding hold-timer (whether the timer is currently running and if running, the remaining
time).
seen on the slave where provisioning failed due to configuration mismatch or due to some other resource
constraints.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
show subscriber redundancy group
Modification
This command was introduced.
5.2.x
557