Network (Bng) - Cisco ASR 9000 Series Command Reference Manual

network (BNG)

network (BNG)
To specify a set of addresses or prefixes inside a subnet, use the network command in Pool IPv4 or IPv6
configuration submode. To remove the addresses or prefixes, use the no form of this command.
network {IPv4_subnet/length [default-router default-router-address ]| IPv6_subnet/length}
no network {IPv4_subnet/length [default-router default-router-address ]| IPv6_subnet/length}
Syntax Description
IPv4_subnet
IPv6_subnet
length
default-router
default-router-address
Command Default
None
Command Modes
Pool IPv4 configuration
Pool IPv6 configuration
Command History
Release
Release 4.2.0
Release 4.3.0
Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
84
Specifies the decimal representation of the IPv4
subnet mask.
Specifies the hexadecimal value for the IPv6 subnet
mask.
Specifies the length of the prefix.
Note The prefix length must be a maximum of 16
bit more than the subnet mask.
(Optional) Specifies the default-gateway address for
the subnet.
IPv4 address of the default-gateway.
Modification
This command was introduced.
Support for IPv6 was added.
Support for IPv4 default-router was added.
Address Pool Service Commands